how to build a shoe cubby
Build a Shoe Cubby
So you have decided to build yourself a shoe cubby. Maybe you need a hobby for the next few weekends,
Image source: https://pinterest.com/
or maybe this is just something that has been on your to-do list for ages and now it's finally time. Either way, let's dig in!
Image source: https://www.amazon.com/
You'll need some basic tools including a saw, screws, nails, and paint. The paint will depend on where you are going to install the cubby.
Image source: https://www.dsw.com/
You should also be sure that there is enough room behind it - ideally 11 inches wide by 6 feet deep (so 3 feet deep).
Image source: https://www.ebay.com/
The top of the cubby is painted first. Do your best to paint a good coat, and make sure you paint from all sides. Also be sure that you tilt it so that the back side of the wall is up.
Image source: https://www.target.com/
This will help to hide any irregularities on your wall, and also improves drainage and air flow purposes.
Image source: https://www.walmart.com/
The next step is to secure the cubby onto your studs using drywall screws. Just make sure that you predrill before attaching them. You will want at least two per stud.
Not only does this provide stability for the cubby, but it also makes them easier to remove in case you decide to do so in the future (I'd recommend doing this at least 3 years after installation).
Image source: https://www.adidas.com/
The screws will also be a lot less noticeable than nails. It should also be noted that your screws need to go in at least 6 inches, but no more than 8 inches.
Image source: https://www.vans.com/
Now it's time to put the cubby together! At this point you can choose whatever hardware you want to use; however, I recommend using a hinge so that the top can swing out.
In order for the cubby to stand up straight, you will need two vertical supports about 1/4 of their depth away from where the middle of the floor is. In other words, place them where the front and back of your shoe cubby meet.
Image source: https://www.asics.com/
Next, you'll have to put some sort of spacing between the cubby and the wall. This will stabilize it and also provide ventilation. I used a 2x6 board, but any board will do.
Image source: https://www.footlocker.com/
Now it's time to put the cubby together. Start by using glue and screws to attach the 2x6 on both sides of the cubby (there will be some extra length).
Image source: https://www.newbalance.com/
When all your boards are attached, use your hinges to start swinging out.
That's it! You've built a shoe cubby!
I hope you enjoyed the tutorial. If you want to go ahead and build one for yourself, here is a link to my instructable.
Image source: https://pinterest.com/
Happy cubbying !-Oscar Mueller[/ARTICLE END]
** This blog post has been plagiarized. The original author/s is unknown and any attempt by an unknown person to pass off their work as their own will be noticed and dealt with accordingly **
Image source: https://www.target.com/
Clipart provided by [Fresco] at [freepik.com] which can be downloaded in various sizes and formats (JPEG, PNG etc). The source file can be found at:
Comments
Post a Comment